CRM Mitchell1, Author at Auto Care Specialists

2011 Buick Enclave
Mileage
216,452
Service Date
9/11/2020
Services Performed
Check out – Found Drive Belt broke, and Alternator, & Alternator to Junction Box Inline Fuse bad
Remove and replace Alternator, Inline Fuse, and Belt
Timothy A. gave our service a 5 star review on 9/23/2020
2004 Mazda 3
Mileage
170,212
Service Date
8/28/2020
Services Performed
Check Out Dying Issue – Found 1. Battery Cable loose and tightened Cables. 2. Engine Torque Mount Bolt missing allowing Engine to move enough to pull Air Tube off Engine, which caused the Engine to die. The Air Tube Hose Clamp is missing. Replaced the missing Bolt and Hose Clamp. 3. Test drive – all fine at this time.
Jonathan U. gave our service a 5 star review on 9/19/2020
2009 Nissan 370Z
Mileage
73,120
Service Date
9/18/2020
Services Performed
Check power windows – Computer scan and Pin-point test Windows – Found Master Window Switch or Body Control Module (BCM) bad
Kyle W. gave our service a 5 star review on 9/19/2020
2007 Chrysler PT Cruiser
Mileage
135,182
Service Date
9/9/2020
Services Performed
CAMSHAFT POSITION SENSOR – Remove & Replace – All Applicable Models
Check No Start – Computer scan and Pin-point test – Found bad Camshaft Position Sensor
ENGINE OR TRANSMISSION MOUNT – Remove & Replace – Torque Mount,One,Rear – [Includes: Adjustment.]
ENGINE TORQUE MOUNT – Remove & Replace – Torque Mount,One,Front – [Includes: Adjustment.]
Rebecca S. gave our service a 5 star review on 9/10/2020
2011 RAM Pickup
Mileage
230,035
Service Date
7/24/2020
Services Performed
Check overheating – Found Upper Radiator Hose blew apart at the Connection for the Thermostat Outlet. Recommend replacing both Upper and Lower Radiator Hoses, because they are both original equipment.
Diagnose Truck dying – Computer scan and Fuel System test – Found 1. Scan – Low Fuel Rail Pressure Codes. 2. Pressure & Volume Test – Bad Lift Pump
FUEL/WATER SEPARATOR ELEMENT – Remove & Replace – In-Line6
RADIATOR HOSE – Remove & Replace – 3500 Both
Remove and replace Fuel Lift Pump
Tow Vehicle
Matthew J. gave our service a 5 star review on 7/29/2020
2004 Honda Odyssey
Mileage
166,289
Service Date
7/16/2020
Services Performed
Diagnose Brake issue – Found Brake Line to Left Rear Wheel is blocked. Remove and replace Left Rear Brake Line.
OIL PRESSURE SENDER OR SWITCH – Remove & Replace – All Applicable Models
Remove & replace Rear Brake Pads and Brake Rotors
TIE ROD &/OR END – Remove & Replace – Outer,One – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some models. If
Alignment
William T. gave our service a 5 star review on 7/18/2020
2006 Dodge Pickup
Mileage
67,437
Service Date
6/10/2020
Services Performed
BALL JOINT – Remove & Replace – R1500,4WD Upper,One Side,Independent Type – [DOES NOT include alignment.]
Check A/C – A/C Compressor is weak. System is full of Freon and has low pressures at idle. At 2,000 RPM's pressures are closer to where they should be.
Check squeaking noise under Vehicle – Found Rear Universal Joint bad. (Which is the source of the squeaking sound while moving.) – recommend replacing Front and Rear Universal Joints
PINION SHAFT SEAL – Remove & Replace – R1500 Full Floating Rear Axle
Remove and replace Front Struts and Leveling Kit
Remove and replace Rear Brake Pads and Brake Rotors
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both Sides – [DOES NOT include disassemble or alignment (where applicable).]
UNIVERSAL JOINT – Remove & Replace – Both
Alignment
Chris G. gave our service a 5 star review on 6/30/2020
2012 Chevrolet Equinox
Mileage
60,758
Service Date
6/16/2020
Services Performed
CAMSHAFT POSITION SENSOR – Remove & Replace – In-Line4 One,Intake or Exhaust – [NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.]
Carbon Vac – Clean Throttle Body, and flush Fuel Injectors
Computer scan and Pin-point test – Found Scan – Code for Exhaust Camshaft Sensor. Test – Checked Power and Ground to Sensor, recommend new Exhaust Camshaft Sensor
Coolant Exchange
Transmission Fluid Exchange
Kathy W. gave our service a 5 star review on 6/17/2020
2006 Volvo S60
Mileage
174,596
Service Date
6/9/2020
Services Performed
Changed Motor Oil & Replaced Filter, Added 5 QTS Synthetic Blend Motor Oil, Lube Chassis, Check all Fluid Levels
ELECTRONIC ACCELERATOR ACTUATOR / THROTTLE BODY – Remove & Replace – All Applicable Models
Remove and replace Mass Air Flow Meter Pipe
Remove Intake Manifold, drill out busted Bolts, and reinstall Intake Manifold
Randy R. gave our service a 5 star review on 6/11/2020
2010 Ford Fusion
Mileage
160,943
Service Date
5/12/2020
Services Performed
Diagnose Rack & Pinion – Found Bolts loose, tightened, and test drove. During test drive – Found Transmission and Transfer Case locking up intermittently and only have Reverse.
Bob O. gave our service a 5 star review on 5/14/2020

CRM Mitchell1

We Service and Repair all CRM Mitchell1 cars